sSNAKESs : Reptile Forum

Go Back   sSNAKESs : Reptile Forum > Community Forums > General Discussion


Closed Thread
LinkBack Thread Tools Display Modes
Old 11-17-03, 06:51 PM   #16 (permalink)
chas*e's Avatar
Join Date: Jan-2003
Posts: 1,036
Drill the holes and then take a piece of emmery cloth or sandpaper to get the burrs for me
chas*e is offline  
Old 11-18-03, 11:53 AM   #17 (permalink)
Syst3m's Avatar
Join Date: Aug-2002
Location: Detroit Area
Posts: 610
Send a message via ICQ to Syst3m
Well I HAVE to put my two cents in on this one.

First for all of you that are using your soldering irons to poke holes in your tank, I sure hope your using some great ventilation since the fumes are toxic toxic toxic..

As far as using a drill bit goes, if cracking is a big problem dull your bit on the cement sometimes a very light tap with a hammer is necessary. I use the same technique for drilling in acrylic. It will cause more of the plastic to melt wich will prevent its from cracking as easy. With any project wich involves power tools remember safety first. Use protective equipment and TAKE YOUR TIME.
Snakes? I just like to teraform!
Syst3m is offline  
Old 11-18-03, 06:01 PM   #18 (permalink)
maiden_canada's Avatar
Join Date: Oct-2003
Location: Victoria BC, Canada
Posts: 534
Send a message via MSN to maiden_canada
i drilled the holes and its fine, i shaved the burs off with a knive, worked like a charm
maiden_canada is offline  
Old 11-18-03, 06:03 PM   #19 (permalink)
Posts: n/a
hot nails
Closed Thread

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -6. The time now is 05:48 PM.

Powered by vBulletin®
©2000 - 2016, Jelsoft Enterprises Ltd.
Copyright © 2002-13, Hobby Solutions Inc.


SEO by vBSEO 3.1.0