Thread: Regurg
View Single Post
Old 04-22-18, 06:37 PM   #11 (permalink)
phenyx
Member
 
Join Date: Feb-2018
Posts: 210
Country:
Re: Regurg

Based on several posts on several boards I decided to use foil HVAC tape to tape the probe to the backside of the heatpad rather than sandwiching it between the pad and the glass. Then I read the instructions for my particular thermostat:

Quote:
• Sensor location: ...Be sure not to place the sensor too close to the heating/cooling device.
So this is the instruction manual for the reptile specific thermostat telling me NOT to put the sensor anywhere near the heat mat. Why the hockeysticks does *no one* make a heat mat with an integrated thermostat?
phenyx is offline