View Single Post
Old 01-10-18, 02:28 PM   #1 (permalink)
Join Date: Dec-2017
Posts: 233
rescuing a big tank, advice needed

I picked up a 75g tank with a cracked side for dirt cheap. I removed the broken side and have a template from foam hobby board that I am going to take to the hardware store to have a piece of plexi cut.

My next challenge is the lid. It is glass with these little panels made of plastic. They are about 2.5" wide. I dont know if I can use these lids because I have to come up with some way to secure them or my red tail will just push her way out. But assuming I can, would it be enough vent to just do holes like this on one half?

I will be using an Ultratherm UTH. Not sure if I will need a light for the red tail or not. Going to try and get away without it I think.
IDvsEGO is offline  
Login to remove ads